DTMEN=DISABLED, DTMINH=INACTIVE, DSTREQF=NOT_SET, DBGMD=RUN, TOERRI=NOT_SET, DMAERRI=NOT_SET, INHF=NOT_SET, INHSSEL=DTMNINH0, DTMI=NOT_SET, SRCREQF=NOT_SET
Module Control
| STCOUNT | Active State Counter. |
| ST | Active State. |
| LASTST | Last State. |
| INHSSEL | Inhibit Signal Select. 0 (DTMNINH0): Select inhibit signal source DTMnINH.0. 1 (DTMNINH1): Select inhibit signal source DTMnINH.1. 2 (DTMNINH2): Select inhibit signal source DTMnINH.2. 3 (DTMNINH3): Select inhibit signal source DTMnINH.3. 4 (DTMNINH4): Select inhibit signal source DTMnINH.4. 5 (DTMNINH5): Select inhibit signal source DTMnINH.5. 6 (DTMNINH6): Select inhibit signal source DTMnINH.6. 7 (DTMNINH7): Select inhibit signal source DTMnINH.7. 8 (DTMNINH8): Select inhibit signal source DTMnINH.8. 9 (DTMNINH9): Select inhibit signal source DTMnINH.9. 10 (DTMNINH10): Select inhibit signal source DTMnINH.10. 11 (DTMNINH11): Select inhibit signal source DTMnINH.11. 12 (DTMNINH12): Select inhibit signal source DTMnINH.12. 13 (DTMNINH13): Select inhibit signal source DTMnINH.13. 14 (DTMNINH14): Select inhibit signal source DTMnINH.14. 15 (DTMNINH15): Select inhibit signal source DTMnINH.15. |
| DBGMD | Debug Mode. 0 (RUN): The DTM module will continue to operate while the core is halted in debug mode. 1 (HALT): A debug breakpoint will cause the DTM module to halt. |
| INHF | Inhibit Status Flag. 0 (NOT_SET): The inhibit signal is inactive. 1 (SET): The inhibit signal is active. |
| DSTREQF | Destination Peripheral DMA Request Status Flag. 0 (NOT_SET): The destination peripheral did not request a DMA transfer. 1 (SET): The destination peripheral requested a DMA transfer. |
| SRCREQF | Source Peripheral DMA Request Status Flag. 0 (NOT_SET): The source peripheral did not request a DMA transfer. 1 (SET): The source peripheral requested a DMA transfer. |
| DTMINH | DTM Module Inhibit. 0 (INACTIVE): The DTM module does not ignore DMA requests. 1 (ACTIVE): The DTM module ignores DMA requests until this bit is cleared. |
| TOERRI | Timeout Error Interrupt Flag. 0 (NOT_SET): A timeout error has not occurred. 1 (SET): A timeout error occurred. |
| DMAERRI | DMA Error Interrupt Flag. 0 (NOT_SET): A DMA error has not occurred. 1 (SET): A DMA error occurred. |
| DTMI | Module Interrupt Flag. 0 (NOT_SET): A state transition or timeout has not occurred. 1 (SET): A state transition (SECSTIEN or PRISTIEN set to 1) or timeout (TOERRIEN = 1) occurred. |
| DTMEN | Module Enable. 0 (DISABLED): Disable the DTM module. 1 (ENABLED): Enable the DTM module. |